Lone Star Bowhunters Association - View Single Post

right_wing · 03-26-2008, 12:08 PM

I've not had any problems. However, I cut about 1/2" off of both the rest arms (the vertical ones) leaving a much shorter "U". I hope that makes sense.

Then I slid the whole rest aft quite a bit so that the "U" does not hit the riser shelf. I seem to have no clearance issues. But, I'm only shooting about 250 fps.

03-26-2008, 12:08 PM	#7
right_wing Junior Member Join Date: Feb 2008 Location: Lorena Posts: 20 Points: 160.00	I've not had any problems. However, I cut about 1/2" off of both the rest arms (the vertical ones) leaving a much shorter "U". I hope that makes sense. Then I slid the whole rest aft quite a bit so that the "U" does not hit the riser shelf. I seem to have no clearance issues. But, I'm only shooting about 250 fps.